1980 FXS Lowrider, original owner. Just had my heads & rocker boxes
powder coated. I'm usin the rocker box bolt setup vs the stock stud
setup as I made that conversion when I switched over to S&S heads.
Was wonderin if rocker bolts go in dry or should I use a little blue
loctite? Will the loctite throw off the torque readings? I'm usin a
James .20" metal with bead gasket, which I'm told is far superior to
the piece o` **** paper with silicon bead (which disintegrated & of
course leaked). I'm assuming these gaskets were designed to go on
dry. Greatly appreciate any feedback. ~Flash~
Shovelheads Forever………..
Last edited by Flash : Feb 7th, 2005 at 10:32 AM.
Reason: Training Wheels???
| 
