[SkyKing]

I have a RevTech 100 with REvTech ignition module. There are no directions on how it should be set for the advance curve. Short of putting the bike on a dino to set it up, any suggestions on proper setting?

[CD]

Without a Dyno, do it the old way. Get the jetting right then start raising the curve one at a time until she rattles and back off one or two curves.

[SkyKing]

Thanks. That's pretty much what I figured. I did that last summer and it ran pretty good up until recently. Now it seems to be getting hotter than it use to, and occasionally diesaling when I shut it down. Could it be the cold air (Jan/Feb in Idaho) is affecting the mixture?