1. After 20+ years it's time to pass the torch. If you are interested in acquiring this forum please contact support@cv-performance.com for details. Any spam will be reported and blocked.
  2. Welcome to Bike Talk, a forum for all bikers and motorcycle enthusiasts. If you are new to Bike Talk, be sure to register for free and join the conversation.

    There's always someone around willing to help out with questions or give a friendly wave back. All Harley and metric riders are welcome.
Bike Talk Motorcycle Forum is For Sale Welcome to Bike Talk

Error Code U1097 Help

Discussion in 'Motorcycle Tech Talk' started by Catsoff, Apr 11, 2013.

  1. Catsoff

    Catsoff New Member

    Joined:
    Apr 11, 2013
    Messages:
    2
    Likes Received:
    0
    Sorry if this is a wrong topic I am new here , be nice.

    I just installed a Combination Speedometer/Tachometer gauge.
    After going through the set up with out a problem, I took it for a ride
    and all was reading fine with the exception that the were strange
    characters flashing off and on through the ride in the speedometer
    part of the gauge. I found the error code U1097. So i cleared it
    rand the bike for 30 sec and tested for the error code again
    and None.
    But the strange characters still flash once and a wile.
    Any one have any ideas.
    No other error codes.
    Bike is a 2007 FXDB.

    Thanks

    Steve
    :gah:
    Catsoff, Apr 11, 2013
    #1
  3. baggerpaul

    baggerpaul Well-Known Member

    Joined:
    Aug 8, 2011
    Messages:
    2,670
    Likes Received:
    108
    Location:
    south fl.
    All uart codes are control area network codes . Body chassis ecm comm codes are you sure that the speedo is can compatible ? Some thing on the comm bus is not happy. And not able to respond back to a specific module on the network .
    baggerpaul, Apr 12, 2013
    #2
  4. Catsoff

    Catsoff New Member

    Joined:
    Apr 11, 2013
    Messages:
    2
    Likes Received:
    0
    Yes its made for my bike. I would not buy it if it wasn't. Only thing this combo does not do on my 2007 is show the gear
    your in. Only 2008 and up does.
    The Code that comes on looks like PSSP6
    The 6 when you hold the reset for 5 sec shows ( No RSP ), and the tach works.
    Ill try to reset that today.

    Steve






    Last edited: Apr 12, 2013
    Catsoff, Apr 12, 2013
    #3

Share This Page

XenPorta © Jason Axelrod from 8WAYRUN.COM