1. After 20+ years it's time to pass the torch. If you are interested in acquiring this forum please contact support@cv-performance.com for details. Any spam will be reported and blocked.
  2. Welcome to Bike Talk, a forum for all bikers and motorcycle enthusiasts. If you are new to Bike Talk, be sure to register for free and join the conversation.

    There's always someone around willing to help out with questions or give a friendly wave back. All Harley and metric riders are welcome.
Bike Talk Motorcycle Forum is For Sale Welcome to Bike Talk

Ignition Settings

Discussion in 'Motorcycle Tech Talk' started by SkyKing, Feb 25, 2005.

  1. SkyKing

    SkyKing New Member

    Joined:
    Aug 7, 2004
    Messages:
    135
    Likes Received:
    0
    Location:
    Boise, ID
    I have a RevTech 100 with REvTech ignition module. There are no directions on how it should be set for the advance curve. Short of putting the bike on a dino to set it up, any suggestions on proper setting?
    SkyKing, Feb 25, 2005
    #1
  3. CD

    CD Guest

    Without a Dyno, do it the old way. Get the jetting right then start raising the curve one at a time until she rattles and back off one or two curves.
    CD, Feb 28, 2005
    #2
  4. SkyKing

    SkyKing New Member

    Joined:
    Aug 7, 2004
    Messages:
    135
    Likes Received:
    0
    Location:
    Boise, ID
    Thanks. That's pretty much what I figured. I did that last summer and it ran pretty good up until recently. Now it seems to be getting hotter than it use to, and occasionally diesaling when I shut it down. Could it be the cold air (Jan/Feb in Idaho) is affecting the mixture?
    SkyKing, Mar 2, 2005
    #3

Share This Page

XenPorta © Jason Axelrod from 8WAYRUN.COM