1. After 20+ years it's time to pass the torch. If you are interested in acquiring this forum please contact support@cv-performance.com for details. Any spam will be reported and blocked.
  2. Welcome to Bike Talk, a forum for all bikers and motorcycle enthusiasts. If you are new to Bike Talk, be sure to register for free and join the conversation.

    There's always someone around willing to help out with questions or give a friendly wave back. All Harley and metric riders are welcome.

Sooty rear exhaust - help!

Discussion in 'Motorcycle Tech Talk' started by dmiller12, Sep 6, 2005.

  1. dmiller12

    dmiller12 New Member

    Joined:
    Sep 6, 2005
    Messages:
    2
    Likes Received:
    0
    2000 XLH 883

    Exhaust pipe coming out of the rear cylinder is coated on the inside with a sooty deposit that is somewhat sticky. Any ideas? Front exhaust pipe burns clean. Bike has only 4700 miles on it. Many thanks.
  2. Killer-B

    Killer-B New Member

    Joined:
    Jan 22, 2005
    Messages:
    841
    Likes Received:
    0
    Sticky

    Somewhat sticky deposits on the inside? :eek: :eek: :eek:
    O.K., I wont go there. :D
    Probably just blow-by, maybe from drive belt?
    Check for the obvious,,,oil from rocker covers, oil lines,trans.
    If oil is leaking onto your pipe you will smell it.

    Good luck.
  3. bluejay864

    bluejay864 New Member

    Joined:
    Apr 24, 2005
    Messages:
    21
    Likes Received:
    0
    Rear Pipe Fat or Oily --------------

    I am going to go with the fact that there are no complaints with the running and performance of this 883.
    Two things come to mind when I hear rear cylinder anything.
    1. The fact that the rear pipe has a resedue could mean more than likley one of the following. #2 cylinder is going to be naturally hotter than #1. This leaves the results of heat. Valve guide wear, allowing oil to get sucked in and blown out. Rings to colapse, or get gummed up in the ring groves, especially that oil ring. That will cause blow by and produce the same problem.
    2. The other thing that jumps out is: Are the spark plugs the same heat range? Gap? And last of all, Are there any air leaks between the carb and cylinder head?
    I understand that these are not all easy for every one to check. There are a few things that are. A manual will break it down, then you can decide how far you want or are able to go.
    bluejay864

Share This Page