1. After 20+ years it's time to pass the torch. If you are interested in acquiring this forum please contact support@cv-performance.com for details. Any spam will be reported and blocked.
  2. Welcome to Bike Talk, a forum for all bikers and motorcycle enthusiasts. If you are new to Bike Talk, be sure to register for free and join the conversation.

    There's always someone around willing to help out with questions or give a friendly wave back. All Harley and metric riders are welcome.
Bike Talk Motorcycle Forum is For Sale Welcome to Bike Talk

What to do about picking heads

Discussion in 'Motorcycle Tech Talk' started by duck, Oct 4, 2004.

  1. duck

    duck New Member

    Joined:
    Oct 4, 2004
    Messages:
    3
    Likes Received:
    0
    I've got a 04 FLSTC:
    95", low comp flat tops
    Daytona twin tec ign
    V&H pro pipe
    HSR 42 Mikuni
    Oil cooler
    Andrews TW-37 Gear Drive cams
    Any advice on rather having the heads ported or just outright purchase of new heads such as Delkron,S&S,etc...
    duck, Oct 4, 2004
    #1
  3. hotroadking

    hotroadking Super Moderator Staff Member

    Joined:
    Jun 16, 2004
    Messages:
    13,682
    Likes Received:
    584
    Location:
    Mouseville USA
    www.motorcyclemachineshop.com is Short block charlies site, they do a scotsman hopup, great price good work reasonable turnaround.

    Some folks had problems a short while back but the shop was overwhelmed by orders after a huge positive write up in the Hot Bike magazine.

    You'll spend way less $$$$$ getting your heads done and SBC works a lot with andrews tw-37B cams.
    hotroadking, Oct 5, 2004
    #2
  4. godot

    godot New Member

    Joined:
    Jul 21, 2004
    Messages:
    47
    Likes Received:
    0
    Location:
    Vista, CA

    Try Jerry Brach - http://www.branchflowmetrics.com/Introduction.htm. Probably the best heads available.
    godot, Oct 5, 2004
    #3

Share This Page

XenPorta © Jason Axelrod from 8WAYRUN.COM