Bike is makin a noise

Well I been beating myself up pretty good tryin to make decesions. To have a 124 built or buying a SE 120R motor.

I Have forgot all about that.

Deceided I will buy a SE 110cu motor and put my 50mm tb on it till I can find out which throttle body is on a 110cu motor.
I can put the motor on myself. Take it to the dealer and have the automatic compression released wired in and I think they have to flip a switch to turn them on and have somebody to send me a download on the PCV.
I will git a warranty and have a dependable motor with more torque.
If I make any changes I will probaly put a Woods TW7 cam in later on.

Got a lot of friends riding SE 110 motors. Buddy at the end of the block has one.
Got a buddy in La that has had 2 103's 1 107, a 124 and a 117 motor in the same bike.
He wound up ordering a 110cu motor and puttin it in his 07 Heritage and did the same thing I'm talkin about doing.
He changed the cam out later on and got like 105 hp and more tq.
And has a nice riding bike that hes not scared to go anywhere on.

are you saying this is the route you are going to take?
i noticed that it is a 5th gear run also, does that mean it won't pull that hard in 6th gear?

I sure do like the dyno sheet numbers on that 120R. I have also been hearing good things about the FuelMoto 107 kit.

Good luck on your new motor, Cardboard!

You can't dyno in 6th gear man.

Did you see who's shop did the dyno ?
Do you know who it is.
Where's Hotroadking when ya need him.
Probaly out drinkin again......

Why ?
Yes I saw who dynoed it.

KNow who Doc is.

I've been told more than 3 times, but I don't remember.
Just know that it is so.
Think its something to do with the gear ratio or something.
Pretty sure Hotroadking would know.

Guess you got up after yer power nap from yer Dear Huntin trip today. HUh....:rant:

I be a northern redneck but don't have all my vehicles up on blocks like cardboard does. :roflmao::roflmao:

CAll Doc and ask him
He will explain it to you.

http://www.docsperformancetuning.com/About_Us.html

Hey REdneck Sarge did you just git up too.
Replaced my water pump last week.

Took my bike to Wolfgang Grasser Tuesday and had it dynoed.
He looked at the map and said man yer bike is lean. He added some ign timing.
And some gas. It cranks a lot better. and runs smoother,

He kept saying it wasn't putin out the power it should oh.

He was lookin at the map tables. He replied. It has a 20% level for change on the auto tune part.
ONly one thing he said. All the tables for all the Rpms are set at zero,.
With them set to zero it has no place to make changes.
He built tables for it and got the hp and torque line smoothed out.
I can tell too. Took the OL Out on a good ride up the lake today
Can tell it pulls better and runs smoother.
Come on down and see if anything here is sittin up on anything.:rant: