1. After 20+ years it's time to pass the torch. If you are interested in acquiring this forum please contact support@cv-performance.com for details. Any spam will be reported and blocked.
  2. Welcome to Bike Talk, a forum for all bikers and motorcycle enthusiasts. If you are new to Bike Talk, be sure to register for free and join the conversation.

    There's always someone around willing to help out with questions or give a friendly wave back. All Harley and metric riders are welcome.
Bike Talk Motorcycle Forum is For Sale Welcome to Bike Talk

DK Low Accel pump nozzle

Discussion in 'CV Performance' started by TTS88, May 17, 2012.

  1. TTS88

    TTS88 Member

    Joined:
    Mar 25, 2012
    Messages:
    2
    Likes Received:
    0
    Location:
    New Jersey
    I bought the DK low back in Feb and installed it into the carb and it seems to be running fine, but I was reading the install instructions the other night and they say to leave a 1/16" gap at the bottom. I remember when I installed it I lined it up pointing towards the slide and tapped it until it bottomed out. I didn't leave a gap. Should I go back in and raise it up a 16th. I would imagine the gap is there for a reason. Would I gain anything by doing that or leave it be?

    Thanks, Tom
    TTS88, May 17, 2012
    #1
  3. kenfuzed

    kenfuzed Administrator Staff Member

    Joined:
    Jan 1, 2005
    Messages:
    10,512
    Likes Received:
    140
    Location:
    Las Vegas NV
    It doesn't make a huge difference however some report that the stream splashes off the bottom walls if not perfectly aligned to spray toward the center. If not a problem for you then I would leave it alone.
    kenfuzed, May 17, 2012
    #2

Share This Page

XenPorta © Jason Axelrod from 8WAYRUN.COM