My buddy's 124

Stop making me laugh it hurts too much

Well got gaskets and seals and lifters on there way to me jugs are in the brown truck in route to be taken care of I'll give you some pics and an update when they get back .I'll also post some pics of heads and work when I get rolling on them

What's happening with Ricks engine? Is it up and running yet?

Still waiting for parts to get here

OK well update is as follows got the jugs back . Cleaned up in 10 thou for a bore size 4.135 new set of je pistons as a new set of rings . Had to go ahead and hone the guides just a smidgen they were on the tight siDE mostly on the exhaust as they tend to varnish up a bit due to the fact as they will pass a little oil .ported the intakes just below the valve seat as the se heads come through with a lot of of casting in that area .don't know why the last builder left it like that.the exhaust side was done? And I went ahead and blended all the ports also .I'll post some pics as I put it together.more to come

The Builder you choose if very important on your build.
Same goes with the set of heads you have done.

And the time they take to look at every part of the motor for you.
And the right combination of parts chosen.

Sucks to have a new engine and got problems out of it.

I think Paul's buddy chose the right builder

And also letting them build a little temp before you beat on them don't hurt either .just saying!

Well got the new pistons oilers installed the ones he had in the motor were to tall and one of them were broke off and sitting inside the case.also got the cylinders washed up and rings file fitted to the front and rear cylinders.

Sent from my SGH-M919 using Tapatalk

Well I have tried to post.pics.off of.tapa talk and off.google .won't load I gave up

Sent from my SGH-M919 using Tapatalk

Thanks jb much appreciated.

Hey CB, check this out. An actual running 124

I can't get video to work


Sent from my iPhone using Tapatalk

Yeah I have no idea WTF is going on